What did u do to your raptor today?

[cbcgeneral]

Forgot to mention the Helium mod.

Oh ya and that too. Lol. You can't talk though because I saw you just did the same thing on another thread.

 

[Houston Raptor]

How hard was it to install the antigravity module

7 on a 1-10 scale. Lol

 

[2014RubyRed]

Installed my 10" M&R Light Bar today. Thing is super bright and built well. Gonna make a great work light / tailgater light.....

 

[Deleted member 12951]

Installed my 10" M&R Light Bar today. Thing is super bright and built well. Gonna make a great work light / tailgater light.....

How is it for an additional backup light? Does it cause glare at the backup camera?

 

[2014RubyRed]

How is it for an additional backup light? Does it cause glare at the backup camera?

Nope. Only tried it in the shop when I shut the lights off, but no glare. It's a spot pattern so doesn't throw a lot of light out the sides, but it's low enough that it doesn't glare at all.

 

[upscrazy8]

Use it for red light cameras. Flash em before they flash you

 

[Ramathorn178]

Shipped my extra shocks to @m3dragon for some help.

 

[t_j]

Heard that before. Right?

Just a few times

 

[siooss]

Battery Maintenance

Removed battery, unclogged the 18 little drain holes in bottom of battery box, cleaned the insulation blanket, used shop VAC and scraper to remove accumulated dirt and debris from bottom and sides of battery box.

Cleaned the posts, replaced the anti-corrosion pads and sealed posts with rust inhibitor after reconnecting battery cables. Used OBDII Memory Saver Connector with my Booster PAC ES5000 to maintain electronic memory settings/learning.

 

[Floyd91]

Pulled the zinc bolts off my new methods and replaced them with some black nylon bolts.