GEN 2 Fox Factory 3.0 damaged bypass hose

[MrGrizzly]

I recently had SVC install Fox Factory 3.0 Live Valve suspension, UCA's, tie rods, their bump stop kit, and +3 deavers. I took my truck out to El Mirage to get a feel for my new setup. I am happy to say that the truck handled just about everything I threw at it, including a few jumps, and then some. However, after all was said and done I noticed damage on my suspension's front left bypass hose. It seems like a surface level perforation, nothing too deep. However, I am not sure if I should be concerned with this and am curious as to what caused it in the first place. Any feedback would be greatly appreciated.

 

[Raptor911]

Looks like it is contacting the inner upper control arm when the suspension is fully compressed. Take it to SVC and show them.

 

[MrGrizzly]

Yeah that’s what I figured and I plan on stopping by SVC to see what they recommend. Should I be worried about the damage as it is? Not leaking or anything but I’d be lying if I told you I knew what to look for...

 

[DFS]

Definitely looks like a result of contact with UCA, any hydraulic hose shop can replace that hose for nothing if it comes to that.