Need a toolbox, what is everyone else using?

[AARaptor]

I have a 2nd gen, 62" from inside to inside of the bed rails

Yea, here is the one I ordered sitting in the bed. Definitely not wide enough.

 

[GordoJay]

Yea, here is the one I ordered sitting in the bed. Definitely not wide enough.View attachment 435442View attachment 435441

I had similar on my ‘62 Chevy. Drilled angled holes through the corners and was good to go.

 

[GordoJay]

And zip ties. Lots of zip ties.

Don’t forget the duct tape and garbage bags.

 

[Sharpie69]

Yea, here is the one I ordered sitting in the bed. Definitely not wide enough.View attachment 435442View attachment 435441

What is the inside dimension of the bed rails? Did they send the wrong box somehow?

 

[AARaptor]

What is the inside dimension of the bed rails? Did they send the wrong box somehow?

Inside the bed rails is about 62.75 inches. The measurement on the box appear correct from the schematic I saw online. It is just about and inch too short

 

[Sharpie69]

Inside the bed rails is about 62.75 inches. The measurement on the box appear correct from the schematic I saw online. It is just about and inch too short

I looked at it again this morning in the light and wearing my glasses, 62 3/8" , that can't be the correct tool box

 

[Bozz]

 

[AARaptor]

I looked at it again this morning in the light and wearing my glasses, 62 3/8" , that can't be the correct tool box

Yup, I also looked this morning, and measured again. They sent me the wrong box. I am returning it, and they are hopefully sending me the correct box.

 

[FoxNotch]

This is what I use, my friends tease me, but when I break down, jokes on them.

 

[Chzhead]

I use the BakBox, https://tonneaucoverhq.com/products/pa-bakbox-2. Works for me as it sits under my tonneau cover (BAK Revolver)