Injen intercooler front mount in stock location

[Ruri]

Injen intercooler $500
used for a month
This mounts in the front stock location
Please no low ballers
Located in SoCal East LA County area
Will ship if buyer pays shipping

from Injen's website
KEY FEATURES
Direct fit for
2015-2020 Ford F-150 V6-3.5L (tt)
2015-2020 Ford F-150 V6-2.7L (tt)
2017-2020 Ford F150 RAPTOR V6-3.5L (tt)
Dyno Proven gains of up to 29 hp and 33 lb-ft. of torque
Outlet temperature up to 30 lower than stock intercooler
TIG-welded Aluminum Bar-Plate
Stock Pressure Drop Retained within 0.5 psi
Designed to work with stock calibration
Increases throttle response and decreases turbo lag
Uses all factory mounting locations
Includes all necessary hardware for a hassle-free installation

View media item 14972View media item 14973View media item 14974View media item 14975

 

[Raptor911]

What SVC bumper were you running? Did you have to remove the IC shroud and louvers with this Injen IC?

 

[Ruri]

I was running the SVC bolt on and I had to remove the inner shroud that went all around the intercooler because this intercooler was double the thickness over stock.

The bumper required to trim a little of the lower shroud due to the bottom connecting to the lower arm support. But the trimming wasn’t because of this intercooler

 

[Raptor911]

were you running the old or the new SVC bolt on bumper?

I was running the SVC bolt on and I had to remove the inner shroud that went all around the intercooler because this intercooler was double the thickness over stock.

The bumper required to trim a little of the lower shroud due to the bottom connecting to the lower arm support. But the trimming wasn’t because of this intercooler

 

[Ruri]

Old

 

[ArisDiaz]

PM Sent!

 

[Ruri]

PM Sent!

sold thanks AriaDiaz