Raptor R Eibach Spring kits
- Thread starter Stormtrooper
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
juice
Active Member
Updates ?
OP
OP
I no longer have my R due to selling it back to Ford under the lemon law. To my knowledge Eibach was still looking for someone to do the final fitting.
juice
Active Member
Have a contact ?
OP
OP
I just sent you the contact via message
signalbobby
Full Access Member
- Joined
- Jul 14, 2018
- Posts
- 242
- Reaction score
- 87
Ooh what happened? What should others be looking out for?
signalbobby
Full Access Member
- Joined
- Jul 14, 2018
- Posts
- 242
- Reaction score
- 87
Just installed the HD rears on the R.
You need 6 ton tall jacks and floor jack to get enough drop on these bad boys.
With about 300 lbs in the bed and 100lb under the rear seat, they are sitting at about 43" both driver/passenger floor to fender (centered on wheel). Factory 37" of course.
Fronts still sit unchanged at 42" driver/passenger.
You need 6 ton tall jacks and floor jack to get enough drop on these bad boys.
With about 300 lbs in the bed and 100lb under the rear seat, they are sitting at about 43" both driver/passenger floor to fender (centered on wheel). Factory 37" of course.
Fronts still sit unchanged at 42" driver/passenger.
Attachments
Roger that, sucks to hear but good ya got closure... Thanks for the update
Any more feedback on the time you did have them on? I.e. would you go this route and/or with updated fronts if you got another R?
OP
OP
When I get my 24MY I will be going a different direction and installing the SDI Bucket Assembly.
SDI Elite GEN 2/3 Ford Raptor Front Bucket Assembly
The SDi Elite Raptor Leveling Bucket replaces the OEM strut mount that is prone to failing on the Gen 2 & 3 Ford Raptor Provides 1.75
Last edited:
