6.2 Header gasket

Discussion in 'Ford Raptor Exhaust and Cutouts Discussion [GEN 1]' started by Anthony k, Oct 15, 2018.

Sponsored By: Stainless Works
  1. Sozzy12

    Sozzy12 Full Access Member

    Age:
    36
    Posts:
    522
    Likes Received:
    244
    Joined:
    Oct 13, 2017
    Location:
    South Idaho
    That could be tricky to weld in-place. Risk warping the head, destroying the gasket, etc. Might be worth it to remove the header.
     
    Jimster58 likes this.
  2. Anthony k

    Anthony k Full Access Member

    Posts:
    52
    Likes Received:
    14
    Joined:
    Oct 7, 2018
    Location:
    Michigan
    There’s not that much heat in a 1/2” long bead.
    Absolutely no way it will warp the head. That can be welded and your bare hand on the same header tube 6” away. Wouldn’t be warm 6” away.
    Have you tig welded before?
     
  3. Sozzy12

    Sozzy12 Full Access Member

    Age:
    36
    Posts:
    522
    Likes Received:
    244
    Joined:
    Oct 13, 2017
    Location:
    South Idaho
    Have you seen the engine bay? Not much room.
     

Share This Page