Dan06
FRF Addict
It's not too expensive to have a shop get the truck on a frame machine and measure the frame to check everything out. I've had it done before after shifting my bumpstomp support a smidge, luckily it was all still to spec.
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
You could measure things yourself and see if anything is out of whack. Sunday is a good day to swing by the dealership and measure a new one on the lot and compare it to yours.
One easy measurement is to measure from the center of the front rim to the back and then check that against the other side, I have seen repaired vehicles come off the frame machine and still have a different measurement from side to side. You could also measure your box from corner to corner and compare those measurements.
Yea as long as the measurements are all good I think you're ok.. Yea time to make some calls to order some parts it's a little piece of mind these mods! I know both companies very well when you call them tell them that pat sent you! They'll hook you up!!