Search results

Do you know if that part number supersede to another one . Thanks

Can I program it with Forscan ?

Does an HVAC module on a 2010 needs programming or could I buy a used one or what will you recommend ?

Understood , So what would you think is the problem if continuity and resistance are good on all cables ? And the code I am getting is short to batter Or open circuit .

Thanks for that info .air distribution actuator (by Gas pedal) Here is where I am at right now I checked for continuity and resistance on all wires from the bottom connector to the top module the one by the dashboard speaker and everything is working to specs , I have a question what sends...

So from what you are saying it should be a broken wire ?

Yes I did clear sorry didn’t notice that the forum only allows for 5 pics this are the , ones that came back after reset. When I had the scanner on and checked for power on the recirculation switch when I pressed it , it never show like it was pressed on , I don’t know if I am explaining...

The one behind your glove box is for the recirculation .

So this are the codes I get Hi , this where the codes I got , and the video is a noid test of the harness that goes to the distribution air actuator ( the one by Gas pedal ) , you can see the only ones that really get power are the ones that are working at this point defrost and feet , the one...

Yes I can pull codes , let me get them and will get back to you . Thanks

So I got both actuators today , first they are OEM , remember I am replacing the recirculation actuator and the one that controls where the air comes out ( one by gas pedal ) replaced both didn’t connect either one until both where installed first connected the one for the recirculation then the...

Thanks I already order 2 to replace the recirculation and the a/c selection at the same time .

Will order a new one a try again will let you know what happens thanks for your time .

When I first installed it ( the one by the gas pedal ) I did not connected it until it was installed and then did not start car until after doing the fuse 15 removal after that it did do the sweep and went to the defrost and wouldn’t move from there , but yes after that I did removed the...

Yes they are all the same , the only one that works is the driver side temperature control actuator

Hi I have a 2010 Raptor scab 5.4 dual climate with touch screen controls I am having issue with the famous a/c actuators I need some guidance . I am having problems with 3 of the actuators first the one that controls where the a/c is going to be blowing middle , defrost , floor ext. That is...

that is crazy. Mine has not made any popping noise or anything and it shifts “normal”while driving And 2wd and awd working without any problem.

Did you had any codes present when that happened? because mine doesnt have any codes present at the time. Thanks

I already did that , that video was taken with the hose loose and the selenoid cap will recheck all heat shields thanks

Here is a video of the grinding noise , is not a constant noise if you drive “normal” is fine the noise only happens on acceleration like when you are going to pass someone Maybe someone has had the same problem thanks

Hi , I did replaced the ck valve

Will do, but have a question why would it do it when is on awd there is no vacuum at that time just trying to understand

I replaced all the lines with oems ones

Hi, I did the job and a mechanic friend help me to do the job

Hi I have a 2010 ford raptor 5.4 engine 84k miles had it since new , I started hearing a grinding noise recently only on acceleration and it will go away like gears are grinding , what I have replaced iwe valve , selenoid, complete vacuum lines from the top to the connection to the iwe’s and...