Had some new Progressive rate Spring made
- Thread starter Johnny
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Very curious about the machining of a new channel, as I was just asking about this recently... Although I was looking for something in between middle and top.
Still perplexed how ppl are preferring low over mid, but to each his own. I would really like more info on how the machining of the shock worked out, who did it, did they break it down etc...
Still perplexed how ppl are preferring low over mid, but to each his own. I would really like more info on how the machining of the shock worked out, who did it, did they break it down etc...
I still really like the springs, they have been on my truck since May 2013 and for over 22k mile; I have no complaints and no CV issues. Most of those miles are normal driving, I don't beat the truck but do take it off road when I get the chance. I run these coils up front and the National springs from RPG in the rear & I would buy them again if I had to start over.
I'm with sitdown I was gonna machine a grove between bottom and mid and try 37s being mid may raise the front higher than the back with deaver +1s I have no intentions of jumping or hardcore wheeling just looking for level truck and filling the wheel wells, guess I'm old!!!
vanilla_gorilla
FRF Addict
Shit damn! Just installed these and my @ReadyLift UCAs and these springs at Mid-Perch are amazing. It's really night and day in the difference.
The road drive feels a bit firmer/controlled, but yet soft and smooth. The little bit of dirt driving is so much more controlled and smooth, the pogo, which really isn't a lot on the stock coils, is gone.
If anyone is on the fence about these, it's a must if you don't want to spend the $5k on 3.0s.
Thanks to @m3dragon for the help and use of his lift and tools.
The road drive feels a bit firmer/controlled, but yet soft and smooth. The little bit of dirt driving is so much more controlled and smooth, the pogo, which really isn't a lot on the stock coils, is gone.
If anyone is on the fence about these, it's a must if you don't want to spend the $5k on 3.0s.
Thanks to @m3dragon for the help and use of his lift and tools.
vanilla_gorilla
FRF Addict
Tell me when and where and we can do that. We can also help with the install.
I'm in Antelope, near Watt and Antelope.
Good deal! Yah I'm right around the corner q and 24th I'll pm you
Towerhog
Full Access Member
Some bad news for those wanting a set of these springs. As of today there are no more in stock (anywhere). Geiser Bros (the manufacturer) is now working on springs for the next gen Raptor. The current model springs might be available in 3 months or so. Check with UTV Inc and they can keep you apprised of the status of the springs.
Similar threads
