This is the reset instructions for the pass seat module. I guess I would what you said just disconnect the battery and see if it resets
OCS System Reset
Turn the ignition to the OFF position.
Prepare the passenger seat for a System Reset and make sure:
the OCS weight sensor bolt harness connections are correct for each sensor at the correct locations. Refer to Wiring Diagrams cell 46 for schematic and connector information. Refer to the illustration for correct sensor location on the seat.
the seat wiring harnesses are routed and secured correctly and are not twisted, pinched, pulling down or pushing up on any seat component. Refer to Seat Wire Harness Routing in Section 501-10 .
all seat fasteners have been tightened to specification as identified in the Workshop Manual. Refer to Section 501-10 .
the seat track is correctly aligned (manual seat track) — check the seat track fastener hole alignment, lift the seat adjust bar to align the holes in the track bracket to the holes in the floor.
the seat is correctly installed in the vehicle.
the passenger safety belt buckle is unbuckled.
the front passenger seat is empty and there is nothing underneath the seat. Remove any items from the seat that were not factory installed.
the seat backrest is in the upright (vertical) position.
the seat is at the mid-point of the seat track travel.
the seat height is in its middle position (power seat only).
the hysteresis has been removed from the front passenger seat by firmly hitting the back of the seat head restraint 3 times.
the vehicle electrical system voltage is below 18 volts and above 11.5 volts before continuing with the OCS System Reset.
Turn the ignition ON, wait 8 seconds .
Carry out the OCS System Reset.
If the System Reset was successful, carry out the Occupant Classification System (OCS) Zero Seat Weight Test. Refer to Occupant Classification Sensor (OCS) System Zero Seat Weight Test in this section.
If the System Reset was unsuccessful, proceed to Step 8 .
NOTE: Do not install any new OCS system components at this time. OCS system components should only be installed when directed to do so.
Carry out the OCSM self-test.
If DTC B00A0:54 is retrieved on-demand, refer to the DTC Charts for diagnostic direction of this DTC.
If any other DTCs are retrieved on-demand from the OCSM , proceed to Step 9 .
Inspect all the items listed in Step 5 for causes of an unsuccessful System Reset, repair as necessary. Retest the system