Recent content by Squatting Dog

I will, be sure to be on the lookout for Wiz write up and review soon.. Sent from my XT1254 using Tapatalk

RCV swag and IWE eliminators

OEM locking ring inside the IWE verses the RCV locking ring.. OEM is unknown material where RCV locking ring is 300M, the same material RCV uses in their axles.. As many FRF members can attest, I have been obsessed with making these eliminators. They have been put through their paces in...

They look like revised links (third generation). Sent from my XT1254 using Tapatalk

Duratracs are good all around tires... Currently I am trying out Cooper Discoverer A/T3 Since the Raptor is currently my wife's grocery getter and is actually spending more time on the road than off road.

Boobs Sent from my XT1254 using Tapatalk

The other part of the puzzle is when the IWE wear, they produce metal shavings. These shavings will get in the needle bearing of the hub bearing. Then when you install the new IWE, the shavings will be in the new IWE and tear it up and ruin the wheel bearings.

In my opinion they seem better, at least the rubber material for diaphragm seems to me to last longer. The price is better, and amazon is better than stealership stock.

Issues have been there since 2004, granted it wasn't until the Raptor came out the issue was accelerated.. Previous years you would see this issue crop up around 60k miles. With the higher hp and the addition of torsen caused accelerated wear and breakage.

Challenge accepted... :)

Yes. Part number 4262688R http://baer.com/15-Rear-Extreme-Plus-Brake-System-4262688.html -Greg (aka Squatting Dog)

Stock rotors 13.8" Both Brembo and Baer have 15" disks for the front. Alcon Rotors are 14" -Greg (aka Squatting Dog)

That is stage 4 spindle... The brake kit will fit stock spindle and many aftermarket. The upgraded hub requires new spindle.. I believe there will be two versions one that requires new upper and lower and one that works with stock/other control arms. (I will verify this) -Greg (aka Squatting Dog)

Price seems high, let's compare to other big brake kits on the market.. Brembo GT Front Brake kit $4,795 No rear kit available Baer Brake kit front $3,895.99 Baer Brake kit rear $3,895.95 Baer brake kit all 4 wheels $7,791 All above kits require 20" wheels, Alcon is the ONLY one able to...

That's right.. This brake kit will bolt on to a fully stock truck if you want. Factory spindles and suspension and 17" wheels. But obviously it will also bolt on to any aftermarket kits that use the same brake set up as stock. 6 piston opposing calipers with better rotors. And yes they fit...