Recent content by ASars

interested, willing to ship? of so 22060

For now the key and Ignition cylinder is removed. I haven't found a way to remove the wheel lock so I could leave the ignition cylinder in as a back up. I do plan to further investigate that one and try to figure it out. not a lot of information out there on the wheel lock.

Diff interested, if not already sold can i get a shipping estimate to 22060

ah ok. well ill be traveling up to Ft Dix coming up (not sure when yet) but once i find out if there still available ill deff contact you.

May have to see if i can make it up that way, or if ur willing to ship

this may help any one else looking to do the install. i used various resources to find the right wires. the colors changed in 2011 mines a 2012 but 13s and 14s may be different too Great Walk thru But for a FRS or BRS so a lot of differences in wiring etc but I found it useful DIY - EasyGo...

ah im in VA to far away.

Where are you located? I'm interested

Install finished. surprisingly easy and straight forward. Seamed complicated until i got into it deff an easy and great mod

Well 90% complete taking a short brake need some wire supplies. Push start works only thing left is to tap wires for the door locks, Lights, and horn. Fully tested it out and works great. just can't lock/unlock the doors or have the lights or horn feed back until I tap those wires. For the Can...

Got the majority of the easy/ smaller parts of the kit installed yesterday. 2 RFID antenas installed above the drivers side, Just pulled the A pillar and the weather stripping (SuperCab) pulled back the head liner enough to fit in the FRPID antennas one towards the back of the truck one over the...

Well May not be the same but worth a shot. My C6 corvette had the same issue. It is a very common place issue on the C6 corvette. its the connectors under the seat. its so common on those cars to the point where chevy acknowledged it and they sell a "fix" which is a zip tie lol. literally just...

yeah thats an idea or as mentioned above the regular F-150s have the hill decent control above the radio screen so you could always swap to that bezel and retain the feature. ---------- Post added at 09:38 PM ---------- Previous post was at 09:37 PM ---------- Plan to get cracking on the...

or theres always the option of adding addition OEM AUXs wasn't to bad a job. Untitled by ASarsano, on Flickr

Can any one post some pics of the brake line routing. Did a Raptor suspension swap on a 2012 F-150 FX4, and I currently can't Run the Raptor Sway bar as it will crush the brake lines on the F-150 (F-150 brake lines come out right behind the upper control arm and would meet the sway bar.) looking...