Top Perch Mod DONE!

[IRONMAN]

Nice Bird! Might have to follow you on this one.

 

[iceman302]

does your top perch mod sit level or is the front slightly higher?

The fender gap will be very close to dead level... maybe a half inch nose high. My SCrew is on the middle perch and I think that's perfect. With my tonneau cover on, the fender gap in the rear is about 1.25" more in back than the front. IMO, its the perfect amount of rake and leaves a little on the table for towing.

 

[6.2]

Beast mode haha I like that. Looks killer man, on to the next mod, stripper pole.

 

[SilverBolt]

Nice! Mine will have to be a midle perch truck to fit in the garage. Not much room to spare.

 

[HoustonRider]

Nice! Mine will have to be a midle perch truck to fit in the garage. Not much room to spare.

a middle perch to fit in the garage? would your roof scrape if it was a 1.5" higher?

 

[crashmc302]

is this an easy enough job to be done in your driveway? I'm not entirely familiar with suspension on these trucks but I'm not afraid to dive in and figure it out. Just wondering if it's not too complicated to do on my own. I'd seen the SDHQ site showing this procedure on their site too. Looks easy enough, just can't really tell w how the shock was separated from the coil. If it's a self explanatory job, I can handle it, just lookin for advice

 

[trolls56]

Who want to come do mine? I don't really have the time space or the tools to do it here. Oh and it looks great Birdman.

 

[BIRDMAN]

does your top perch mod sit level or is the front slightly higher?

fender to the ground is about the same.

 

[SilverBolt]

a middle perch to fit in the garage? would your roof scrape if it was a 1.5" higher?

It would. Garage opening is 81-1/2".

 

[iceman302]

fender to the ground is about the same.

What about the fender gap between the bottom of the fender and the top of the tires?