Recent content by RC Blk Bird

Well sparky they put the redline on the tach for a reason. Like one responder indicated the 3.5 ** truck motor is pretty tapped out from the factory. The only way to get more out of it is to build to GT specs - different cams, heads, intake, tune, etc. I think even the block may be different on...

Well I know dealers are not proactive about applying TSBs unless you point them out and demand it. My guess is all the excess pressure the turbos put on the crankcase ventilation system probably causes them to leak. I am already over it as it's going down the road and I am on to my next truck...

I would take that deal in a heartbeat. I am so done with my Gen II. I haven't had any problems with it but... the 3.5 is a poor motor in my book. I just can't figure why they didn't Coyote power theses rigs. Here's my compliant. When changing the oil at the service interval, only 5 qts comes...

Cam Phasers are on the ends of the overhead cams on the 3.5 ecoboost motor. They provide variable valve timing by altering the cam phasing during different engine loads. They are hydraulically actuated by the engine oil so using the correct spec oil is fairly important. Ford's supplier of these...

I've had black , tan, & white rigs. I just run them thru the carwash. They come out mostly clean, or spend 4 hours n do a detail job. Bottom line I don't get crazy making it look like some street queen. Out here we have this look it's called AZ pinstriping. Bring your rig out n do several runs...

I wouldn't recommend Rhino. Had a very bad experience. I had my bed sprayed in the Avalanche color (twice the cost of black) since my truck would spend a lot of time in AZ and I didn't want a black liner. This was done October in SC where I purchased the vehicle. After six weeks in the sun...

During the Gen 1 days the course was offered for $1250. IN 2013 I met the director of the Ford Performance school at SEMA. They offered the Raptor and Mustang GT courses for 1250 each or a combo for like 2100. You had to own one of the vehicles to qualify. Not sure if they still offer the buy in...

Gen 1 16 city 17.5 hwy Gen 2 18 city 19.5 hwy Mainly drive in normal mode w steering set to sport for heavier input. I don't drive in sport or like an ******* all the time as I don't like buying tires every 20k.

your too lame

FYI - Ass load of driveline specs @ http://www.dieselhub.com/trans/transmission-tech.html

Straight from Ford Ford 10R80/GM 10L80 Transmission Specs Transmission: Ford 10R80, General Motors Hydra-Matic 10L80 Type: 10 speed automatic Production Plant: Ford 10R80 Ford Livonia Transmission Plant, Livonia, Michigan GM 10L80 Romulus Powertrain, Romulus, Michigan Model...

65 n sunny in AZ today - ice - we put that in Margaritas :)

The numbers are metric trans rating e.g. Newton Meters - you have to convert to ft/lbs 800 = 590 1400 - 1032

Current SD runs 6R140 transmission 6-speed automatic 2020 runs 10R140 transmission (a heavy duty version of the 10-speed automatic) F150's (Raptor as well) & Chevy light duty run 10R80 10-speed automatic jointly developed by Ford & GM The 140 designates trans rating in newton meters - 1400...

The right rear quarter doesn't look too happy