So, looking at the diagram above, my switch for the steps have 2 wires. I assume I would hook one of the wires to A, B, or C, but where would the second wire go.... to the ground?
So simple. Makes sense. Do you know of a simple relay on Amazon that would work for this?
Would this work? https://www.amazon.com/dp/B074QV54V1/?tag=fordraptorforum-20
Does anyone know if there is a way to make one of the upfitter switches to act as a simple on and off switch (no power)? I may be stupid here but here is my situation...
I have a set of RBP Stealth Steps and their wiring harness comes with a two-wire switch that allows me to stop the steps...
What? You have no right. I am going to have to send a cease and desist. All that money I have lost because of you. :)
I have an Adobe Illustrator document if that would be easier for people to edit and make their own. I uploaded it here.
Not sure who sells them on Amazon, but I saw them and was too cheap to buy those. That is when I thought I would do my own. But when I was going to print my 6 switch labels out, I thought "that is a waste of a whole sheet". So I made more.
I am working on getting my Cricket cutter to be able...
I updated the file to v2. I got rid of the "AUX" ones and put these instead.
If you guys want to give me some good sayings, I can make a PAGE 2 with those.
Marty
I went a little overboard when I started to make my own switch labels for my 2019 Raptor. I figure you guys might like to use them yourselves.
I enclosed a PDF of the file for the high res. These only fit the newer Raptor type upfitter switches.
If you have a printer, you can just print them...
I am wondering if anyone has figured out how to have the low beams AND the parking lights? I can only get parking lights to work without the standard low beams
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.