Recent content by GaoKS

I don't think my drivers side goes up, only down... lol. The ass goes down, and the front goes down. Just not up. or maybe I am just not noticing it.

Sick truck! Congrats!

Thank you!!!

Ditto!

Unless you have a crazy specific build, I'd try and find one incoming. My original 1/17 truck is still in Dearborn.

Arrived via rail to KC 4/1, officially unloaded "received" in Vinview at the KC Ramp, 4/4. Truck didn't update again until 4/17 but actually arrived 4/15 at the dealer 2 hours away.

Lol. I an affinity for Toyota as well for various different reasons. Between 4Runners and Raptors - I'm on Number 10.

I think if I remember correctly, and it's the same install process as 21-23, there is 3M around the edges and then clips in the center of it. I am trying to figure out if it bothers me enough. Either way I wont address it until the 10k first service. I am sure it's backordered as someone...

I think they're 3M'd on the edges and then also clipped in the middle.

Couldn't agree more. I still didn't like them in photos, like them more in person. May end with different wheels but at least it wont be an immediate change.

My peasant model also has the applique that is a bit loose on the corners when pushing on it. Really all 4 corners. I know there is supposed to be 3M around the edges but these are also held in via clips throughout the tailgate, no?

I am holding for now so by all means! OP - I just saw your last DM, my bad.

I think mine is the exact same then. That said, I have no idea if my last two truck were the same. I never specifically went pressing around the corners of the appliqué. Is the entire thing held in with 3M? Edit - looked at it again this morning. Corners are definitely looser than I'd like...

I checked mine and didn't have any of the issues. Minus a slightly gritty shifter. Not to the point I'd consider taking it in. That's said, on the appliqué. My corners aren't pulling away and are fairly flush. But all have some "play" when pushed. Yours?

Thanks!