Looking to wire my rigid dually's in my add rear bumper to the up fitter switches. just looking for advice on best route from rear to engine bay? thanks
Alright despite all the snow, ice, and road salt, I loosened everything up and made some adjustments and sprayed it all with silicone. Seems fine now. they were definitely binding up a bit. I called AMP and they were helpful but pretty much said exactly what you all said. thanks!
they are with the OBDII. and i have had to unplug a few times so i could read codes (another issue). i noticed the problem has started since i have had to unplug it, could be a coincidence?
I have newly installed AMP power steps. occasionally they don't retract all the way. instructions say they could be binding and tell you to unbolt one of the actuators and adjust. i did that and they still randomly decide to not fully retract. if i give them a little push on the way up they...
They are 37's. I'm on mid perch up front and just the drivers side needed extensive trimming of the fender flare. I smashed the pinch welds on both sides. drivers side I had to trim more of the flair though. now the damn tpms warning light is on. after all the reading I did on the 37's I was...
Finally got the raptor. I am extremely impressed! wow what a truck. put the new wheels and tires on today and i had a lot of rubbing! had to trim a lot and still need to do a little more.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.