Search results

  1. Primez

    Gen 1 with 4 Auto (TOD)

    Worth noting that the first gen TODs from 12-14 do not have a full lock. It’s clutch plate only. 4H and 4L just basically is full pressure. But yeah, if you’re like totally crammed up on some rocks, in 4L, and trying to climb boulders, definitely want to be careful if the TC starts to slip / get...
  2. Primez

    Gen 1 with 4 Auto (TOD)

    No, the TOD does not bind ever. TOD has clutch plates instead of a fixed lock between front and rear that will allow slip for this scenario. You’ll burn out the clutch plates and toast the TC before you get binding. The front open or LSD should also allow and compensate for different wheel...
  3. Primez

    Long Trip in the Raptor Pulling an RV Trailer

    I tow a 31’ trailer with my truck. Running the SVC Baja v3 rear bumper as well. 37s, 4.56 gear ratio, Deaver +3 with a 2” shackle, Gen 2 coils, Eibach springs, and KHC coil buckets. I average about 7.5 mpg going up hills in CO and 25mpg on the way down. :) With the generator and dirt bike in...
  4. Primez

    Gen 1 with 4 Auto (TOD)

    Yes, that’s exactly right. The caveat is that the 12-14 TOD TCs do not technically have a full “mechanical lock” in 4H. Everything is clutch driven, unlike the Gen 2 TOD which has clutch for 4A but a mechanical lock for 4H. 4H for the 12-14 TOD is just 100% clutch pressure. Important piece to...
  5. Primez

    In the current market, what is the best upgraded head unit for a 2010 with Nav?

    I’ve had this unit for a few years now. Very happy with it. My only complaint is that the wireless CarPlay seems to have a memory leak, creating a delay on audio. The screen and CarPlay remains incredibly responsive, but the audio slowly lags more and more over time. After an hour, there’s like...
  6. Primez

    I would like to go TOTALLY off the board for 2,000 Alex...'07 MXK 3.5 valve train question...??

    Check all the bolts/pulley wheels. I forgot to tighten one of my pulley wheels once after rolling a timing chain. I thought I threw rods and was getting ready to toss the engine. Just one pulley wheel was loose and was rattling like CRAZY. Obvious with the wheel being attached to the belt, the...
  7. Primez

    Front and rear suspension upgrade

    I have run this setup on the front in every configuration imaginable, to include Gen 2 shock with Gen 1 spring on an unmodified Gen 1 bucket. Can confirm that the IWEs, axles, etc also do not like being put at extreme angles like top perch or extra length of the Gen 2 shock without proper...
  8. Primez

    Best front diff for front off replacement - 2010 6.2

    Worth noting that the second clip shows the faults of these differentials but this effect would be even more exaggerated if you had one wheel in the air, for example.
  9. Primez

    Best front diff for front off replacement - 2010 6.2

    Honestly, I did a bit of research and found that the Wavetrac has the same faults as Torsen in a 0% traction scenario. Both differentials require some amount of braking to trick the differential to send power to the wheel with traction. Since AdvanceTrac is doing the brake modulation...
  10. Primez

    Front Differential

    Any 8.8 will fit. Maybe consider going for the offbrand Spicer version? Basically same, just different brand plate. You could put a sticker on it if you hated that much.
  11. Primez

    Best front diff for front off replacement - 2010 6.2

    I am in the process of doing this mod and gears. Upgrading to 4.56 for the 37s. Torsen is a drop in and frankly easier than trying to re-gear the OEM open diff. Everything is completely self contained. You may want to consider new bearings if you’re doing the swap, rather than trying to...
  12. Primez

    Please help identify previous owner mod

    For the sake of saving someone serious headache and catastrophic damage, do not remove those rings. There are two on each shock, both angled. The OEM F150 bucket was not originally designed for the longer length shock and angle of the Raptor LCA. To compensate, these angle brackets sandwich the...
  13. Primez

    ECLIK 2017-2021 Raptor Fox Live valve controller

    Oh, thanks guys. Good to know. Wasn’t aware of the changes. I’ll reach out and share my findings.
  14. Primez

    ECLIK 2017-2021 Raptor Fox Live valve controller

    I’ve been looking into the E-Clik system for quite some time. Also spent some time watching through the KeepItDirty videos. One thing I want to point out, for the sake of preventing misinformation, especially for Gen 3 guys is that the KeepItDirty dude constantly talks about calculations per...
  15. Primez

    IWE tips/tricks/diagnosis??

    Easiest way to diagnose is to lock the IWE. Vacuum is present to disengage the IWE. There are two simple ways to do this: 4H or pull the vacuum lines. For the 4H trick, on a straight (or dirt road), just put the truck in 4H. If you are on pavement and/or can’t get into 4H for whatever...
  16. Primez

    Gen 2 Tailgate For Gen 1?

    First time seeing this thread but I can confirm the 2015+ tailgates are not a direct swap. Width is the same but height and mounting points are different. Body lines are also different. Your taillights will not align with the lines on the tailgate. Fiberwerx has a set of bedsides that can align...
  17. Primez

    Gen 1 with 4 Auto (TOD)

    Yes, turning in full lock, no issues with binding at all. I have been in 4A since the install. Wet, dry, highway, parking lots, dirt, full lock, etc etc., and no issues with binding at all.
  18. Primez

    Gen 1 with 4 Auto (TOD)

    AFAIK, all the magic happens in the 4x4 module. I think the big question is whether or not those are interchangeable between the 10-14 years. The parts listed in my original post show compatibility for 12-14. The TOD was also introduced in ‘12, so my hunch is that likely something (probably...
  19. Primez

    Gen 1 with 4 Auto (TOD)

    Anyone have a length comparison of Gen 1 vs Gen 2 drive shafts? I wonder if the Gen 2 is coincidentally about 1” shorter? :) @SVTRap did you order the TOD 4x4 module and if so have you had a chance to test out the off-road mode and hill descent for compatibility? I believe that is the final...
  20. Primez

    Gen 1 with 4 Auto (TOD)

    I replaced my IWEs 3 or 4 times, hardlines, soft lines, and check valves. For whatever reason, my truck was plagued with failing IWEs. After the last replacement, I gave up on them and just left them locked. Haven’t noticed any major differences in driveability. Though, the rubber boots seem to...
  21. Primez

    Gen 1 with 4 Auto (TOD)

    the only piece of the puzzle that remains is whether or not the off road mode and hill descent will continue to function. I suspect yes but this would be a simple thing to test with just the module alone. If someone were to swap the 4x4 control module, while leaving the system in 2H, you could...
  22. Primez

    Gen 1 with 4 Auto (TOD)

    I just took my truck to Breckenridge during the snow storm. 4 Auto the whole way. It was magic.
  23. Primez

    Gen 1 with 4 Auto (TOD)

    When engaged in 4A, the IWE will release vacuum and engage the front axles. This way, when traction is needed, the transfer case immediately engages the front axle and moves power forward. I already had the IWE delete which was a big motivator for this mod. Even after switching to 2H, I often...
  24. Primez

    Gen 1 with 4 Auto (TOD)

    I found this very helpful explanation on another forum describing the differences between the 2015+ Lariat TOD vs Gen 2 Raptor TOD. I believe the TODs that would be available for 2012-2014 are described below as the “non-mechanical” TOD below. The mechanical locking feature was probably not...
  25. Primez

    Gen 1 with 4 Auto (TOD)

    Ok so stumbled on something that may throw a wrench into the swap for you purebreds. Fords Website advertises some of the control modules for the TCs to specifically call out “without hill descent” and “without off-road mode.” The TOD module does not specifically call out a “with” or “without”...
Top