Recent content by Palmetto_Raptor

Negative. Had a few things come up and then that delayed me a couple weeks and by then the virus thing was getting started and I didn't want to mess with installing them in the middle of it. They are still in the box and probably will be until after this blows over.

Getting ready to swap out my Baja Designs Unlimited kit with new Diode Designs SS3 Pros. For my BD setup I have Sqad pro driving combo's with yellow lens on the inside, Sqad racer spots in the middle, and S2 pro's on the outside that I run 24/7 Will be replacing with: DD SS3 pro yellow...

On my previous F150 I found a headlight extension. Basically a male and female plug that could be plugged in-line behind the headlight. You tap into the extension so you don't have to cut the factory harness. Something like this. Don't know if they would work with the 2019 Raptors but...

Just stumbled onto these on EBAY. My button has not cracked yet but it sounds like they all crack eventually. The sticker also comes in black with orange letters if you don't like red. I think the red looks cool and goes with the red stripe on the steering wheel...

Post a link to those decals on ebay! I like the looks of those.

I'm interested in these lights. I'll bite. The discount code set the hook:) Just ordered your bracket, DD SS3 SAE Pro Yellow Fogs, DD SS3 SAE Pro White Fogs, and DD SS3 SAE driving combo.

and the final touches of putting 3/8" split wire loom over wire where is goes into frame

Someone should make a flanged mounting bracket that would cover the cuts in the grill. They would sell a bunch of them.

Is your 10" onx6 Amber? How do the S1's compare to S2 pros? Thanks.

Any plans for an SAE S1?

Done. https://www.fordraptorforum.com/threads/s1-backup-lights-install-part-ii-running-wire-to-engine-compartment-inside-the-frame.72971/

Here's the install thread https://www.fordraptorforum.com/threads/s1-backup-lights-install-part-ii-running-wire-to-engine-compartment-inside-the-frame.72971/

I'm waiting for someone to ding my door before I take it in the mud:) Only problem is, those grit covered running boards are too high for most car doors to hit my doors without hitting the running boards!

more... Here's a link to the 6-pin Deutch connector with pigtails. I had originally planned connecting to the upfitter wires using single pin Weather Pack connectors but I changed by mind after thinking about the chance of plugging the wrong plug in and blowing a fuse. Could see this...

more...