Unfortunately not… it’s a bit more offroad than that… looking at carrying a rally bike with the extra fuel across a rally route back to the bivouac for a W2RC event.
https://abudhabidesertchallenge.com/
Any one got any more recent links / suggestions on how to fit/fix something in the rear to allow you to carry a heavier bike like a rally bike in the bed safely off-road?
Looking at taking the truck on sweep team duty for one of the local rally raids. Feedback welcome.
Coolant Change: Orange is discontinued - go for Gold or Yellow?
Gold is compatible with the 6.2 and it’s cooling circuit, listed for it 09-10MY. Yellow is the latest spec.
Need to replace the radiator, so will do hoses and water pump. This will be a full flush and refill.
Gold I have in...
There is that… but the opening to the car port is right onto the street and out in the sun. Better than when I did the plugs, coils and interior/exterior detailing back in August… was lows of 30’s to highs of near 50’C with high humidity and UV. Was brutal. Weather improving by the day now though…
Anyone able to confirm if this is the OEM / Motorcraft equivalent of the Roush / FEAD 3200mm belt?
Roush Kit: FEAD 6k - 6K3200-8620
OEM Equivalent = JK61013B / 7C3Z8620N ??
Serpentine Belt - Ford (7C3Z-8620-N) - 2008-2010 F250 Superduty 6.8 +AC
Got out the truck earlier and could smell coolant… it’s sprayed up for front behind the fan, across the RHS chassis leg, up the thermostat hose and intake pipe, as well as pooling at the front/centre of the motor and dripping onto the ground.
After and initial panic of seeing it around the top...
I bought these after someone posted this pic on the Gen 1 Raptor bookface page. Empi 86-2338-D & 86-2340-D. Pair of successfully rebooted CV axles (half shafts, drive shafts, as you like) if this is your pic and you’re on here, have a virtual beer you absolute legend. :favorites13:
Went to take mine off… same problem. Tried with a pry bar bar, no bueno. Need to drop the metal bumper and swap it for the annual test anyway… will try and get at the clip from the front once the bumper is off. Should at least be able to spin it round.
As above… mine is a 2014 Screw but I believe they are all small rack 1-5/16” tie rod and 2-1/4” rack OD?
Empi have kits… Empi most likely the OEM of the drive shafts, I believe they are Empi 86-2340-D and 86-2338-D part numbers, as taken from the Gen 1 Raptor bookface page. Some kind gent...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.