Recent content by Mark in Oregon

I’ve got the Icon springs. I’d highly recommend them!

I just finished my build with Retrax XR/CVT Shasta/Max Modular 14”. Perfect setup. See my post under a similar thread I posted this morning.

I just finished my RTT build on Monday with a KB Voodoo 14” aluminum Max Modular rack, Retrax XR tonneau cover with T-slot grooves, and CVT Shasta hybrid tent. Voodoo makes an adapter to put the rack on the T-slots, but I did redo the drill sites on them to make them flush with the tonneau rail...

Thanks everyone for the great advice on the racks!

Looking to put a rack over my LineX (made by Retrax) rolling bed cover to mount an overland tent system. Any recommendations for racks that can be installed with the bed cover in place? Also any rec's on specific tents? Thanks in Advance!

I measured pre install and as best I can recall the fronts were equal at 40 1/4” and the left rear was nearly 41 1/2” and the right rear was maybe 2-3/16” lower to start. The right rear is still just a hair lower than the other 3- certainly nothing you’d ever notice. I had local Les Schwab shop...

Yeah, I was going to go with the 1.5” collars as I was about 1 1/4” or so low in the front compared to rear. With this in mind I thought the 1.5”ers would be more than enough to level it. Since I’d seen some people were level with the smaller and some were level with the other, I thought to call...

Thanks! Yeah, I’m 41.5” (ground to fender flare) all the way around and I’ve got a Line-X retractable cover which adds a little weight to the rear. If not for that, I might still be a little low in the front, even with the 2.25” collars.

I have a magnet metallic 2019 and was looking for the best option to level it. Finally decided on RPG perch collars. Was going to go with 1.5” collars like many people suggested, but called RPG and he recommended the 2.25” to level my 2019 truck. I went with those in orange to match the...

What are the advantages of going Eibachs instead of collars??

I know this has been beaten to death a bit on the forum, but looking for “best” way to level and lift my 2019 Raptor. I have a retractable bed liner which adds some weight and leaves my front height at 40.25” and rear height at 41.25” stock. I’d like to get both front and rear to about 42.5” or...