Anyone know the load rating on the OEM non-beadlock wheels (2018 model)? Not looking to replace them any time soon, especially when I'm just using the truck for some trail explorations.
A negative offset will push the wheel even further away from the hub, which could explain the rubbing. Bare in mind that the stock wheels have a 34mm (positive) offset which is already an inch+ closer to the hub than your method wheels. If you’re planning on keeping those negatively offset...
For those that have installed the regular or 10.9 version of the SPC kit, did you install all 8 pieces or only the 4 outer washers?
I have no problem drilling the location holes for the inner cams but not sure if it’s worth it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.