excited to see head on pictures of it from a distance, front and back. I'm very curious on how those fenders look with your current suspension/wheel setup.
Just had this happen today.
problem:
No gears shifting into D, R or M upon vehicle starting. happens on vehicle restart.
solution for now.
Resetting TCM via cobb. Gears back after reset.
extra info:
cobb, goosetuned e85 and TCM tune.
battery is still original factory, 2020.
also noticed...
Contacted vividracing for clarification on the caliper brackets model # BSK4415X618 if if does come as two brackets like what was mentioned on here or not.
This is the link I found on this thread:
https://www.vividracing.com/alcon-front-bracket-kit-ford-f150-2021-p-156259599.html
I ordered...
there's a section on the fast lane past of orangethorphe northbound on SR-57 that has a very obvious bump that shakes and unsettles my 2020 whenever I go over it. it has been that way with my truck ever since I got it new all the way to now with icons and eibach springs.
but everyone has...
I replaced the brake position sensor a couple of months ago even though the sensor tested ok, maybe the replace the brake pressure sensor as well?
you recommend any other troubleshooting avenues to check out besides the ones I jave already done?
was already there when I did a scan a while back. that code doesn't have a lot of diagnostic info online.
it feels like the accelerator is functioning similiar to a momentary on/off switch. as soon as I lift off the accelerator, the truck feels like it hits a wall.
also performed a live...
Makes it easier and less mess draining the fluid for pan drop, filter replacement.
Just an added convenience, but convenience nonetheless.
It took about 1.5 hours when I swapped to a ppe aluminum pan. If you have the time and basic tools, it's not hard to do.
I was leaning towards the wilwood kit because of the price, but after doing some basic fitment check, I went with ebay roush alcons.
based on the kit dimensions, it needed at least 10mm more clearance with the caliper edge and face.
also spoke with wilwood to confirm the dims I used to build...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.