I just mounted a set of Rigid Ignite (surface mounts) under my rear bumper, but haven't finished the wiring yet as it's too damned cold to finish it outside in one day. While I was looking over how to route the wiring back to the upfitter switch leads, I didn't see any obvious way to route the power wire that was clean and didn't get too close to hot exhaust or engine parts.
I'm sure I'll figure it out once I get some more time to look around, but does anyone who's wired rear lights on the Gen2 to the upfitter leads in the engine bay have any recommendations on the wire routing?
Any comments appreciated. Thanks.
I'm sure I'll figure it out once I get some more time to look around, but does anyone who's wired rear lights on the Gen2 to the upfitter leads in the engine bay have any recommendations on the wire routing?
Any comments appreciated. Thanks.