Just wanted to reach out to the people on here who are running Boatec fenders. I started fitting the fenders last night and must say, as I was slowly aligning everything up, I was super impressed with the fitment. Little trimming here, little trimming there, the only thing that I really didn't like was the door to fender gap was not consistent, mainly between the running board and the trim line on the door. Meh, **** it, right? They are aftermarket and fiberglass, I knew the fitment wouldn't be like factory. But when I threw the headlight in......sigh.
Anyways, anyone with boatecs run into this before and if so, any tips on how to correct this would be much appreciated.
Anyways, anyone with boatecs run into this before and if so, any tips on how to correct this would be much appreciated.
Last edited: