Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Registered members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
RAM TRX - TRX-Forum.com
Bronco Raptor - BroncoRaptorForum.com
Forums
GEN 2 (2017-2020) Ford F-150 Raptor Forums
Ford Raptor Lighting Forum [GEN 2]
Routing back up lights wiring
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Seartrip" data-source="post: 1099253" data-attributes="member: 21701"><p>I just mounted a set of Rigid Ignite (surface mounts) under my rear bumper, but haven't finished the wiring yet as it's too damned cold to finish it outside in one day. While I was looking over how to route the wiring back to the upfitter switch leads, I didn't see any obvious way to route the power wire that was clean and didn't get too close to hot exhaust or engine parts.</p><p></p><p>I'm sure I'll figure it out once I get some more time to look around, but does anyone who's wired rear lights on the Gen2 to the upfitter leads in the engine bay have any recommendations on the wire routing?</p><p></p><p>Any comments appreciated. Thanks.</p></blockquote><p></p>
[QUOTE="Seartrip, post: 1099253, member: 21701"] I just mounted a set of Rigid Ignite (surface mounts) under my rear bumper, but haven't finished the wiring yet as it's too damned cold to finish it outside in one day. While I was looking over how to route the wiring back to the upfitter switch leads, I didn't see any obvious way to route the power wire that was clean and didn't get too close to hot exhaust or engine parts. I'm sure I'll figure it out once I get some more time to look around, but does anyone who's wired rear lights on the Gen2 to the upfitter leads in the engine bay have any recommendations on the wire routing? Any comments appreciated. Thanks. [/QUOTE]
Insert quotes…
Verification
Post reply
Members online
Havok_RLS2
ImjustSteven
nelsonr103
WH7
lakebum
2010 Shelby
loganl86
alockbox
never_summer
offcamber
Rekkr
MidLifeRaptor
Forum statistics
Threads
93,190
Posts
1,955,691
Members
56,469
Latest member
ngodavid23
Forums
GEN 2 (2017-2020) Ford F-150 Raptor Forums
Ford Raptor Lighting Forum [GEN 2]
Routing back up lights wiring
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top