UCA and 3’lift

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Max FR

Member
Joined
Oct 19, 2022
Posts
34
Reaction score
5
Location
France
Hi guys, I just installed the Eibach 3’ coils on low perch and the truck sits way higher than with the stock springs at mid perch. The front is now 1/2 inch higher than the rear. I am going to sort out this by lifting the rear slightly but my question is: with such a lift on the front, are adjustable UCA’s mandatory to setup a correct geometry ? There is a pretty important negative camber now.
Thanks
 

Pacific Wheel

Supporting Vendor
Supporting Vendor
Joined
May 19, 2016
Posts
2,972
Reaction score
2,430
Location
Reno, NV
Adjustable UCA's will help dial the alignment if it's too far out of spec with OE UCA's. The UCA and axle geometry would remain the same due to the lift though.
 
Top