Can anyone identify a loose part please?

[AKSteve]

I think you found the bowl to Leroy's bong.

Yeah, if that white part was metal, you could totally put a sink faucet mesh insert in there and use that to make a bong.

 

[Azholley]

Yeah, if that white part was metal, you could totally put a sink faucet mesh insert in there and use that to make a bong.

Sent from my iPhone using Tapatalk

 

[downforce137]

its assembly line stuff.. probably goes on the end of a pin to line up the body and frame or bumper, or whatever it was stuck in.

 

[Firemedic269]

Can you pull them apart and post a photo of the back side of our suspected bump stop?


It also looks like a rubber bumper from a factory tailgate extender.

 

[SilverBolt]

It's either a muffler bearing or the fill cap for the blinker fluid.

 

[Azholley]

It's either a muffler bearing or the fill cap for the blinker fluid.

X2. I just checked this and can confirm my truck has them. Reinstall immediately or your warranty will be voided.


Sent from my iPhone using Tapatalk

 

[sp2pilot]

It might help if you have a picture of where on the truck you pulled this piece out off. Then others can check the same area(s) of their trucks.

 

[xxaarraa]

It is the wheelie control button.

 

[srs]

Looks like a ********!

For the life of me I couldn't remember where I left that.....thanks!

 

[FlyingBear]

Can you pull them apart and post a photo of the back side of our suspected bump stop?


It also looks like a rubber bumper from a factory tailgate extender.

Here it is separated from the white plastic piece: