SPYC-2X
Full Access Member
Hey Gang!
Unfortunately, I do not have time to fine-tune my light setup to commercialize and sell. But I do have time to share the parts list with everyone who expressed interest and might want to take a stab at a similar DIY job.
Here you go:
1 6000-6500K Strip LEDs (5M) $33.75
2 End Caps with Wire Hole $1.95 ea
2 End Caps No Wire Hole $1.95 ea
2 Anodized Aluminum Housings (2M) $19.95 ea
2 Frosted Low Profile Lens (2M) $17.95 ea
1 12V LED Dimmer Switch $4.99
1 3M Outdoor Mounting Tape $4.99
1 12V 19mm Angel Eye On/Off Switch – search eBay ~$8.00
2 3/8” Rubber Grommets ~$3.00
1 Brushed Aluminum Knob – already had laying around
~25’ 18ga. Wire
Solder
Misc Crimp Connectors
Heat Shrink
And be sure to share photos of your bed lighting. It would be great to see what others have come up with, too! Here are mine...
Unfortunately, I do not have time to fine-tune my light setup to commercialize and sell. But I do have time to share the parts list with everyone who expressed interest and might want to take a stab at a similar DIY job.
Here you go:
1 6000-6500K Strip LEDs (5M) $33.75
2 End Caps with Wire Hole $1.95 ea
2 End Caps No Wire Hole $1.95 ea
2 Anodized Aluminum Housings (2M) $19.95 ea
2 Frosted Low Profile Lens (2M) $17.95 ea
1 12V LED Dimmer Switch $4.99
1 3M Outdoor Mounting Tape $4.99
1 12V 19mm Angel Eye On/Off Switch – search eBay ~$8.00
2 3/8” Rubber Grommets ~$3.00
1 Brushed Aluminum Knob – already had laying around
~25’ 18ga. Wire
Solder
Misc Crimp Connectors
Heat Shrink
And be sure to share photos of your bed lighting. It would be great to see what others have come up with, too! Here are mine...