Discussion in 'Ford F-150 Raptor General Discussions [GEN 2]' started by Jepper, Jan 5, 2018.
Proof the raptor OEM DPs aren't robbing much power.
For sure. I wanted a set of those (cast) but wanted to put the OMF Rings instead since they have the holes in them to drain out water, and emailed fifteen52 and that's when they told me the rings were welded on. Since you have the forged ones you could totally do those rings if you wanted. They are pretty cool
That’s the ones I have I’m pretty sure.
Edit: Looking at the pics, they’re a little different.
Oh crazy. They are probably made by the same company, just a modified design for the 20" wheel vs 17"
This is a little off topic but it’s something ‘I’d like to do to my raptor today’
There was a dude here years ago that made these cool side step extenders for the Gen 1s. They were like a non-lame mud flap. He welded them up and powder coated them to match. Anyways they worked really well and I had mine for 4 years with no issues.
Is he still around and does he make them for the Gen 2s? It’s a must have if he’s still selling them.
Was my thought too. Hard Pass.
So it goes into the body shop on Monday, for when the idiot backed into me in a parking lot, and yesterday some b***** pulled out in the lane next to me and hit me behind the passenger door. That’s two, three it’s gone.
nice install! How did you run the wires?
Thanks you Sir
Finally got my magnetic mount installed. I'm a lefty. I made a custom 3D printed part that used an existing bolt hole. No drilling or adhesive. Took me a few iterations to get the fit I wanted. I can rack and remove it in one motion. The Tritium sites look cool in the dark. Now I need to got clean my truck after looking at these pictures.
Separate names with a comma.