Discussion in 'Ford SVT Raptor General Discussions [GEN 1]' started by CAbimmer, Nov 8, 2012.
Installed RPG bed support after it was Line X.
About a week late but I just finished it up.
I say "finished" because I wasn't happy with the final fit and finish of the brackets that hold the top cover down... the top of the lid was sliding inwards towards the engine. I did follow the directions but I ended up pulling the small retaining tab and tacking on two little notches no bigger than about a quarter inch and then I ended up sliding thru the engine back and then using the supplied bolts.
Drove it 850 miles today. Stopped in Laramie Wyoming for the night
Gave the ole girl a slight facelift:
Got it cleaned.
What’s the over/under on how many parts you break on this trip?
Its always None
Doesn't that magazine blow off when you drive it??
Did the same headlights on mine a few weeks ago. Love the way it looks.
Sent from my SM-G970U using Tapatalk
1st post in August - put some fresh fuel in it !
Separate names with a comma.