Trouble codes on start up

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Kikit2

Member
Joined
Jul 8, 2022
Posts
10
Reaction score
0
Location
Winchester, TN
Today I turned my truck (2013 Raptor) on to go somewhere and I had three messages pop up on the screen.
* Check 4x4
* Hill descent control fault
* Check brake system

Trouble codes U0102, B1596, U0114

Earlier this week I ran a new power cable for my amp and when I touched it to the battery terminal it sparked, so I initially assumed I had just blown a fuse. I have checked every fuse that the truck has and all are good. What's funny is that when I installed my CAI months ago I forgot to plug up the cable going to the MAF sensor and I got the exact same errors. I checked that cable today and it seems fine. I have read forum after forum with other issues, but can't find anyome with this same problem. So I'm really not sure where to go from here. Any help would be greatly appreciated because I have to drive it in 2 days to go out of town.
 

Attachments

  • 20221110_122323.jpg
    20221110_122323.jpg
    177.5 KB · Views: 4
  • 20221110_122314.jpg
    20221110_122314.jpg
    437.1 KB · Views: 3
  • 20221110_122153.jpg
    20221110_122153.jpg
    137.4 KB · Views: 4
  • 20221110_122258.jpg
    20221110_122258.jpg
    193.5 KB · Views: 4
Last edited:
OP
OP
Kikit2

Kikit2

Member
Joined
Jul 8, 2022
Posts
10
Reaction score
0
Location
Winchester, TN
Just an update, I ended up dropping it off at the Ford dealership this morning and they called me this afternoon to tell me that there was a wire that was frayed close to the grommet going out the passenger side of the firewall. They repaired that wire and no longer is it showing any error messages.
 
Top