Help Support Ford Raptor Forum by donating:


Those who installed a JLT catch-can

Discussion in 'Ford F-150 Raptor General Discussions [GEN 2]' started by Edbert, May 30, 2019.

  1. FL4x4

    FL4x4 Member

    Posts:
    19
    Likes Received:
    19
    Joined:
    Sep 14, 2019
    Location:
    Orlando, FL
    JLT.JPG
     
  2. 84 Sheepdog

    84 Sheepdog Member

    Posts:
    1
    Likes Received:
    1
    Joined:
    Jan 23, 2020
    Location:
    Dallas, TX

    Bringing up an old thread I know lol. Just installed on my 3.5 and the hoses are definitely too long. I had to get creative with routing them in order to get everything to fit. If you route them the way they are pictured in the instructions for a 3.5 there is no way to reinstall the engine cover. The line going to the PCV also has to hang down pretty low in order to clear the cover. I noticed the other hoses in that area are wrapped in heat reflective tape since they are pretty close to the passenger side turbo. Hopefully this isn't an issue down the road. I'm sure this is a universal kit to keep cost down but IMO they should make a kit specific to this truck so it fits correctly.
     
    Biggwrm likes this.
  3. AVJ19SCAB

    AVJ19SCAB Full Access Member

    Posts:
    65
    Likes Received:
    28
    Joined:
    Jan 30, 2019
    Location:
    Virginia
    This...
     
    Biggwrm likes this.

Share This Page