Rear slide window

[WetDirt]

Hoping for advice that is easy AND cheap (lol). Behind the rear seats, I had pulled the contoured material cover that goes over the rear wall, seatbelt mechanisms and window motor to pull wires for lights I installed in the rear bumper. I bumped the cable that goes from the motor to the window, its spring popped out of its “cradle” so it lost tension and just leaned over. I popped it back in. I decided to see if it worked still, so I hit the button. Motor is fine, cables did not snap but the little plastic tab that connects the cable to the window broke and then the cable un-spooled. After 10 minutes of F-bombs, I just put the cover back on & pretend it didn’t happen.
Is it “fixable” DIY or other? Who/ what shop does it?
Thanks

 

[Zeusmotorworks]

Don't have that answer but if you cannot replace that one part and know someone who's a good 3d printer and can scan, maybe glue scan print?

 

[2slo4u]

I had something similar happen to my Sierra Denali. Had to buy and install the entire motor and cable system. Want too difficult

 

[itsrichierich]

Had this issue while in Mexico the over the weekend. I held the close button for too long while the satellite phone antenna was ran through the window, snapped off those plastic tabs that hold the cable.

I bought this off ebay: https://www.ebay.com/itm/2658947540...d=link&campid=5338805043&toolid=20001&mkevt=1

I called a window shop to see if they can remove the slider window, replace this piece and put it back together. Will report back on the turnout.

 

[WetDirt]

You can get the part from the dealer for $16. There’s 1 great YouTube video. You need a special drill bit from harbor freight ($4). Took me an hour to replace it

 

[WetDirt]

Had this issue while in Mexico the over the weekend. I held the close button for too long while the satellite phone antenna was ran through the window, snapped off those plastic tabs that hold the cable.

I bought this off ebay: https://www.ebay.com/itm/2658947540...d=link&campid=5338805043&toolid=20001&mkevt=1

I called a window shop to see if they can remove the slider window, replace this piece and put it back together. Will report back on the turnout.