GEN 1 IWE 4WD actuator- CV axel gap

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Vash

FRF Addict
Joined
Mar 13, 2011
Posts
1,009
Reaction score
468
Location
OK, USA
Make sure that the ring inside the IWE and the teeth on the axle end are actually splined together during install. The Ford procedure actually specifies pulling vacuum during install, but you can also just rotate and align the splines carefully by hand before torquing everything down as an option.
 
Top