Discussion in 'Ford F-150 Raptor General Discussions [GEN 2]' started by C7 Carbon, Jan 17, 2019.
Interested in this
Thanks again for your orders, we greatly appreciate your business!
Please post pix for the side vents and carbon hood on a gray '19 raptor please. I am so close to placing the order, but not sure if the contrast is enough to justify the expense.
ALSO, how hard is it to install the hood and the side vent pieces without breaking the OEM ones or the CF ones?
I just removed both. The side vents are easy to get to and remove. The hood vent is a PIA. It has 6 nuts under the hood insulation, you can reach about 5 of the plastic clips too from underneath, but it has 16.... yes 16 fasteners in total. Took a couple hrs to carefully remove. They also tape the back side of it down in-case 16 fasteners were not enough....
Demolished a couple fasteners removing them. Ford says the clips are only available if you buy the entire new grill for $200.
Anyone have a source for the hood vent plastic clips?
1) What size 2x2 twill is the carbon fiber?
2) Can you make the side vents in full carbon fiber, with no fiberglass for added strength and lighter weight?
3) Do you sell or know where we can get replacement plastic hood vent clips if the factory clips break while removing the hood vent?
Don't get fooled no one probably order
So where is the OP to answer the above questions?
Crickets again. Been happening for a long time boys
So what are the benefits? Just looks? Curious if that's all it does, buy some stick on over molds
My wife thinks I only have 3 guns
Separate names with a comma.