DIY Radius bend/ frame cut bumper

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Jakenbake

FRF Addict
Joined
Sep 20, 2017
Posts
1,792
Reaction score
2,448
I think the mounting brackets are the same as mine, however it looks like your resi is pushed further forward in it.
I'll take a closer look at mine and post pic from that angle. My driveway pictures are not great.
Ohh, I’m glad you brought that up. I had to use an adjacent hole (further reward) since the holes the directions call for were cut off when I was getting my bumper fabbed. So the bracket were pushed back and the resi’s are roughly where they would have been with the frame horns still present.

Funny how quickly one can forget something.
 
OP
OP
Canuck714

Canuck714

FRF Addict
Joined
Jun 11, 2012
Posts
1,097
Reaction score
872
Location
San Antonio TX
I snapped a couple oics of my front set up, and am not worried at all that the forward facing resi will be an issue. You would litereally have to stand the truck on its end to contact the resi. Even at full bump, the distance to the ground is not going to cause contact.IMG_0369.jpgIMG_0370.jpgIMG_0371.jpgIMG_0368.jpg
 
Top