Hello, Everyone. Looking for a little help please! I'm installing the Ford Performance Carbon Fiber shifter in my 2019 Raptor. The new carbon shifter has the DM button on the side of it and my OEM shifter does not. The new shifter has 5 wires and my OEM has only 3 (gray,red,blue). Obviously, The 2 extra wires (brown/yellow) are for the button. My question is should I just plug it in as is or cut the 2 wires that are for the DM button? If I plug it in as will there be any issues and will the DM button actually work? I did look in the other connection for the shifter wires in truck and it does look like there are 5 pins in that connector. I figured someone has already done this so I thought I'd ask. Thanks for the input!
Carbon fiber replacement shifter
- Thread starter BLJ
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
2020FordRaptor
Full Access Member
Let's see what @FordTechOne has to say about this. He is always very helpful.
Gen1TillDeath
Full Access Member
just grab a beer, Plug that mother in and hold on!!!
Last edited:
Mark McAwesome
Active Member
Mark McAwesome
Active Member
2017-2018 has the button on the side and that Part Number is HL3Z-7213-HB.
2019-2020 is listed on post #5
2019-2020 is listed on post #5
did you have a coupon it $299
downforce137
FRF Addict
is there wires in the other end of the connector on the truck side? if there is it might work, but if theres no wires, then no worky
Mark McAwesome
Active Member
No that was just the price when I bought it a few weeks ago.
Similar threads
