Search results

Ok, I need to replace front and rear pads and rotors and I’m not looking to go big with a set of Alcons. I’m looking for real world experience with stock replacement aftermarket set ups. I’ve had good results with EBC in the past but that vehicle is an overland rig. is ready…go!

I was recently gifted a set of fab tech upper control arms. They are missing hardware, but appear to be brand new and the story goes that they were on display at some shop that has now gone out of business. Just curious if anyone has experience with these? I don’t see them on fabtech’s website...

I have a 2018 802A truck with 52k miles and zero engine/tune modifications on it other than disabling start/stop via FORscan. It will intermittently go into a no crank no start condition that occurs after a short trip of 5 to 10 miles. It typically happens if I pull up to a location and shut it...

During 110 miles of off-road awesomeness last weekend, I managed to strike something and destroy the passenger side roost/rock shield on the truck. I can't seem to find a stock replacement one anywhere and need some help locating one. My plan is to replace it, add the aluminum shock guard from...

Hello All, I’m getting ready to install the @swarfwork bedside antenna mount and was curious where you guys have passed wires from the exterior to inside the cabin? Ideally, I’d like to find an entrance at the rear of the truck, run the antenna wire along the floor/sill plates, and route up to...

Hello All, I've been lurking through the forum for a while and it's finally time to say hello! I’ve got a 2018 802A Super Crew. So far I’ve mastered the art of FORscan modifications, installed Sync 3.4, upgraded to factory bead-lock capable wheels with Nitto Ridge Grapplers, and installed the...