Search results

  1. H

    GEN 2 Cobb Intercooler Install Help

    Yes, you have to remove the main grille shutters to install the COBB IC.
  2. H

    GEN 2 Cobb Intercooler Install Help

    That is the Adaptive cruise control module connector. That module lives behind the plastic cover on the driver side of the bumper like you found.
  3. H

    Anyone getting an engine code with Cobb Intake and UPR Catch Can?

    What codes are coming up, and does your friend also have the Cobb intake ?
  4. H

    What Intercooler to Buy??

    Subarus run off of a MAF based system while the Raptors Ecoboost engine runs off a MAP/ IAT based system. The MAP system is not effected in the same way as a MAF when using a BOV to atmosphere since it is basing calculations for fueling on the pressure in the manifold and intake air...
  5. H

    Stage 2/2+ Hard Parts and Off The Shelf Maps Now Available!

    I took some measurements on a truck with a Cobb intercooler on and found that there is approximately 2.15" between the back of the grill and the intercooler core below the Ford logo and 2.35" above the Ford logo. So you can take a look at how far back your lights go behind the grille and see if...
  6. H

    Stage 2/2+ Hard Parts and Off The Shelf Maps Now Available!

    You can use a turbosmart BOV on this intercooler kit. The BOV is mounted as high as possible without being integrated into the intercooler core/end tank assembly itself. Even with the ADD pro cutframe bumper on, which leaves a lot of area exposed, the BOV stays safely behind the skid plate of...
  7. H

    COBB AccessPort Mounting Options

    This is what the COBB mount will look like. It uses a 1" ball mounted into the existing front handle bolt hole. The cable can be discretely run through the steering column.
  8. H

    COBB tuning Raptor tune

    https://www.cobbtuning.com/2017-ford-f-150-raptor-support-is-here/
  9. H

    COBB tuning Raptor tune

    @BlazinPond The Accessport will have a feature that allows adjustment of the throttle sensitivity, so I don’t think there will be a need for both the Pedal commander and Accessport.
  10. H

    ACC Sensor Alignment after New Bumper ??

    According to the Ford calibration procedure, the front face of the sensor should be leveled vertically with a combination square when the truck is parked on a level surface. The horizontal alignment is done automatically through the truck/sensor software. I'm not sure of an easy way to check the...
Top