Search results

  1. C

    Steering wheel shakes after the power steering pump was replaced

    Thank you for your advice! I will try to bleed air out. I am thinking whether it could be a possible defect in the high pressure hose that I installed. I just noticed that with the engine being cold within a couple minutes after the engine start, the steering functions perfectly smooth. But once...
  2. C

    Steering wheel shakes after the power steering pump was replaced

    Hi, Guys! I need your advice. I replaced the high pressure hose that leaked steering fluid on my 2013 Raptor. Then reassembled the system and did several complete revolutions of steering wheel from one end to another before adding more fluid. After these routines I felt that my steering wheel...
  3. C

    Tpms new sensor pairing

    Hi, guys! I've got one of TPMS sensors dead in my 2013 Raptor with Sensor Fault message displayed in the dash. I ordered 2 new sensors from Ebay with the same part number as the old one(DE8T-1A180-AA). Having installed a new sensor and travelled over 50 miles I activated a sensor training...
  4. C

    Misfire cylinder 1 detected

    Actually dealers have rejected any repairs. They could only replace spark plugs and wires. I have ordered a new harness from Ebay and replaced it myself. So, upon my experience, Ford dealers of St.Petersburg are unable to provide good service for Raptor truck
  5. C

    Misfire cylinder 1 detected

    New harness fixed the problem !!!! I really do not care what was the root of problem since it is fixed. It feels so good to drive my raptor with no annoying misfire! I drove my truck to a dealer twice. They replaced spark plugs, coil, wires and injector - no help... And charged me for all these...
  6. C

    Misfire cylinder 1 detected

    Thank you! The problem seems similar to mine. I tried to bend a harness today to reveal problems. Unfortunately, engine was running all right... Idle engine runs always fine. With 1 or 2 gear it runs fine at any RPM as well. With gear 3 and 4 misfire occurs at 4200 rpm even if I speed up...
  7. C

    Misfire cylinder 1 detected

    Hi guys! I am experiencing misfire cylinder 1 (P0301) on my truck. (2013, 6.2L, CrewCab, 25K miles, all stock) Problem always happens under heavy acceleration when RPM exceeds 4000. Check Engine light goes blinking. Engine hesitates for a minute and then returns to stable run until I accelerate...
Top