On GEN 1 trucks the Aux #1 and #2 switches are 30A fused/relayed. So you should be good. Regardless, if you connect a device that pulls 15A to a circuit rated for 15A, you should be fine. There would be no need to use the RC fuse/relay in your case. Just be sure to make good connections...
OEM paint on all of it. You can see the imperfections in the pics, but there is no rust. A chip and dent in the center of the bumper, and a scratch on the right side. All the bumper parts, skid and mounting hardware in the pictures are included.
I just installed a 20" RC LED bar in my ADD Venom Bumper. I cut the relay, fuse, and switch off of the harness. Just ground the black (-) to an existing point near the light and run the red (+) to the pass-thru. The upfitter switches are wired with the necessary fuse and relay. I would...
I have an OEM Gen I bumper, skid plate and mounting hardware available. I can get pics later, but it is in very good condition (only 30k miles on truck). Asking $400
Located in New Hudson, MI
I have an OEM Gen I bumper, skid plate and mounting hardware available. I can get pics later, but it is in very good condition (only 30k miles on truck). Asking $400
Located in New Hudson, MI
I have an OEM Gen I bumper, skid plate and mounting hardware available. I can get pics later, but it is in very good condition (only 30k miles on truck). Asking $400
I have an OEM Gen I bumper, skid plate and mounting hardware available. I can get pics later, but it is in very good condition (only 30k miles on truck). Asking $400
I may be late to the party, but I just purchased my '14 Raptor last week. I have already used FRF for looking up a bunch of information. Thanks for sharing!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.