Search results

Gen 2 upper mounts Pay shipping from Dallas

Gen 2 springs Pay shipping from Dallas

Still available?

Want rears if you are willing to ship.

Would you entertain shipping the rears?

Want the rears! Can drive down from Dallas if shipping is outrageous.

Grounded mine behind the kick panel on a 10mm bolt, like in the 1st Gen video that guy posted on YouTube. Ill try regrounding it elsewhere tonight.

Installed mine last night. Parking/brake LEDs work, reverse light works. But, spot lights wont work on Aux switch nor does center white spot when doors are open. Did you guys ground behind the pass kick panel? Cuz instructions say on back of cab wall, but you'd have to remove ground wire from...

Want. Can PayPal money asap!

Interested if all of the above fall through.

Method Standards with custom rock rings I machined at work.

This is about the most current one I have. Dont have a whole lot of photos of the truck and Im not really active on auto forums as I used to be. Family life took over.

Finished up my custom Boatec liners about a week ago. The only tweak I may do is open up the area above the strut tower a little higher.

***GONE*** Method The Standard center caps. Never put on the truck. You pay shipping from Dallas, TX

When you guys installed this does the steering rack need to be supported when putting the bolts through the bottom 2 holes of the bumper? As far as I can see it just those 2 9" bolts holding it to the frame. I cut off my frame horns off yesterday but ran out of daylight. Pulled one of the...

Disaster post poned... I guess. The dumbsh;ts at O'reilly ordered me the wrong shafts. After getting them out and laying them side by side I couldnt even compress the old ones to the extended length of the new ones. I put the old one back in for now until I can find correct replacements. Went...

Having an issue with installing a new half shaft. I guided the splined end into the transmission, I felt the snap ring catch but it doesnt go in all the way and it wont come back out. I basically manhandled the old one out since the boot is about to tear, Im not worried about treating it...

I had my coworker run it on our FedEX account from LA to Dallas. Comes to like $153. Too steep for just shipping. Ill pass. If it were for both fenders Id be all over it.

PM sent

PM sent

I sent all 4 of mine to Fox to have them revalved. Its $125 a piece. I have an extra set of fronts and I bought an extra rear and swapped those 1 at a time so I could still drive the truck. Rears are a piece of cake to swap, only 2 bolts. Fronts are a little more tedious, unbolting the UCA is...

I DL'd the 1st gen and added textures myself. Did a sweet little animation for my portfolio. Here's a still shot of the animation. I had to model and add things like the sunroof, wheels, 2013+ projectors and Nittos Im constantly DL'ing 3d models from all over the net for work. Got a pretty...

$3300 and some change. ---------- Post added at 09:17 AM ---------- Previous post was at 09:14 AM ---------- PM sent

Already fixed. I picked the truck up Friday. They had if for 1 week. I just brought it to the closest dealership to my house with the highest Google rating. I really dont like going to dealerships at all, had a lot of bad luck and poor care for my vehicles at dealerships in the past. Been...

No tune, just a K&N intake I had misfires on #4 and #8, was hoping it was just bad plugs and coil pack...