What did you do to your Raptor today? (Gen2)

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Sloracer

Member
Joined
Feb 1, 2021
Posts
29
Reaction score
51
Location
Bay Area
For me, getting the bezels on was a PITA. The lights go on pretty easily once the bezels are installed. I can tell you I ended up using the following spacers and washers:

  • On the Driving/Combo and the SAEs, I used 2 thick washers, spacer, and a thin washer above the bracket and a thin washer below the bracket, along with the locking nut.
  • On the S1s, I used 2 thick washers and a thin washer above the bracket, and a thin washer below the bracket, along with the locking nut.
Of course it may differ for you, but that's what worked for me. I also bought some longer bolts today because with all of the above, I had about a single thread left and didn't like that.

Did you have to purchase or dig up the washers/spacers from the garage or did they come with the ORA kit? Great info by the way, I'll pick up some additional supplies BEFORE I start the project instead of half way thru the project like normal!
 

dblack

Full Access Member
Joined
Sep 15, 2019
Posts
406
Reaction score
304
Location
Alabama
Did you have to purchase or dig up the washers/spacers from the garage or did they come with the ORA kit? Great info by the way, I'll pick up some additional supplies BEFORE I start the project instead of half way thru the project like normal!
It came with all of the washers and spacers. Plenty of those actually. The bolts are 1/4-20 and M8-1.25 I believe, then you can just get whatever length will work for your spacer and washer setup.
 

K223

FRF Addict
Joined
Sep 15, 2019
Posts
5,178
Reaction score
3,444
Location
Florida
Top