Morimoto Announces NEW 2nd Gen XB Headlights for Gen2 Raptors

OK lights are installed! Work great, no DRL wire yet but the DRLs work fine.... I did have the forscan drl mod though were it was just the halos so maybe that is why they work?

nikhsub1 said:

OK lights are installed! Work great, no DRL wire yet but the DRLs work fine.... I did have the forscan drl mod though were it was just the halos so maybe that is why they work?

Click to expand...

I always wondered if that would work without the DRL harness. May have to get a forscan license, the fewer wires added to the engine bay the better.

CobraJay said:

I always wondered if that would work without the DRL harness. May have to get a forscan license, the fewer wires added to the engine bay the better.

Click to expand...

Yeah so moral of the story is if you really only need the 'DRL' wire if you want the startup animation, which is the least of my wants but the wire is run so might as well tap it now.

Pic in some bright sun.




Sent from my iPhone using Tapatalk Pro

nikhsub1 said:

Pic in some bright sun.




Sent from my iPhone using Tapatalk Pro

Click to expand...

Looks really good!

I am holding out for the Gen XCs with six lights in each housing.

Awesome!

Aimed them. I did some quick googlefu- it says to get the center of the headlight from the ground. Mine was around 41” or so. Then they say to set the cutoff 2” below that so i marked the wall at 39”. Anyway, seems good to me. What are you guys doing?




Sent from my iPhone using Tapatalk Pro

nikhsub1 said:

Yeah so moral of the story is if you really only need the 'DRL' wire if you want the startup animation, which is the least of my wants but the wire is run so might as well tap it now.

Click to expand...

i think the harness also gives you full time drl besides the bugatti sequence. Thinking of throwing my drl to a upfitter switch so i can go full dark at night.

rayofsi said:

i think the harness also gives you full time drl besides the bugatti sequence. Thinking of throwing my drl to a upfitter switch so i can go full dark at night.

Click to expand...

I have full time drl without the harness.


Sent from my iPhone using Tapatalk Pro

nikhsub1 said:

Aimed them. I did some quick googlefu- it says to get the center of the headlight from the ground. Mine was around 41” or so. Then they say to set the cutoff 2” below that so i marked the wall at 39”. Anyway, seems good to me. What are you guys doing?




Sent from my iPhone using Tapatalk Pro

Click to expand...

Sounds too high. Remember, on these new versions you have FOUR low beam projectors. Measure from the ground up to the center of the LOWEST projector. Then subtract 2" from that #. I originally did the top 2 projectors, because I used to the old style. WAY too high, and I remembered "ohhh yeah there are 4 LED lows now" so I re-measured to the center of my lowest projector. SPOT on.