ADD "ed" pro bolt on front bumper + BD lights

smgilles · Jun 6, 2020

LF LandShark 2818 said:
Did you relocate your ACC? And if so what bracket did you use? Im about to install mine and i got the BajaMod ACC bracket but cant find any install guide or write ups from folks who have done it.

I do not have ACC on my 802A.

Tomhorn · Jun 6, 2020

I would be careful putting anything there if u havent relocated your turbo intercooler even front plate blocks it ****** placement. I have a 14 which light bar is great there. 19 i got 42 “ bar from f150 leds and set up 3 fogs sae white amber infared be careful of the intercooler is my only advice theg run hot

Gaptor · Jun 6, 2020

Tomhorn said:
I would be careful putting anything there if u havent relocated your turbo intercooler even front plate blocks it ****** placement. I have a 14 which light bar is great there. 19 i got 42 “ bar from f150 leds and set up 3 fogs sae white amber infared be careful of the intercooler is my only advice theg run hot

I have 0 problems with my intercooler and heat soak. With the CVF I run about 25 degrees over ambient at a cruise.

Gaptor · Jun 6, 2020

smgilles said:
Overall it was an easy install even by myself. It's a clean and simple design. Fingers crossed it doesn't rust..... I still haven't figured out how to attach my front plate (swarfworks vs 3M tape?). I had the fog lights set up with spots, driving combos, and S2's, so wiring already in place for adding the amber driving/combos. I moved the S2's to the rear.

View attachment 145053
View attachment 145054
View attachment 145055
View attachment 145056

I used black zip ties to hold it to the add cutouts on mine and looks fine

Miggy · Jun 6, 2020

I have the bumper and used add’s bracket relocator. It turned out fine. The relocation of the acc is a pain in the ass but it works fine.

smgilles · Jun 6, 2020

Thanks for the plate ideas guys! Also, my Whipple IC runs much cooler than previous stock IC too. I measure temps via COBB AP.

hekster1 · Jun 6, 2020

BroncoAZ · Aug 5, 2020

Gaptor said:
I used black zip ties to hold it to the add cutouts on mine and looks fine

View attachment 145106

Is that a 30” or 20” SR bar?

Donovan · Aug 13, 2020

Good to know that people have a nice looking aftermarket front bumper without having to relocate the FMIC.

That is another few hours of work.

What other bumpers can be used that doesnt require FMIC relocation?

chi_weezy · Aug 19, 2020

I’m also about to install this bumper. Figured I’d throw in the CVF IC while I was at it. Tackling this project soon

ADD "ed" pro bolt on front bumper + BD lights

smgilles

FRF Supporting Member

Tomhorn

Active Member

Gaptor

Full Access Member

Gaptor

Full Access Member

Miggy

Active Member

smgilles

FRF Supporting Member

hekster1

Full Access Member

BroncoAZ

Full Access Member

Donovan

FRF Addict

chi_weezy

Well-Known Member

Similar threads

Members online

Forum statistics

Latest posts