Saudi Transmission Cooler

Tasca Parts is all confused as to why I would want a different cooler than the OEM.

Could someone please give the proper part number for the Saudi Transmission Cooler that is the right fit for our Gen 2 Raptors?

Thank you!

That was only for GEN 1 not sure Gen 2 is same mounting inlet and outlet. On my Tremor

1BAD454SSv2 said:

That was only for GEN 1 not sure Gen 2 is same mounting.

Click to expand...

Oh, OK, thought it was for all Raptors.

You could cross check the original part numbers between gen 1 & 2. If they’re the same I would take a flyer on the gen 1 saudi one for yours.

WELL, the only other choice it seems is the expensive Mishimoto tranny cooler for $300+.
I know they make nice stuff but their customer service seems to be very slow most of the time.
Not sure what to do, hoping someone who has perhaps installed the Saudi Gen 1 into a Gen 2 will chime in.

pastorwug said:

Mishimoto is hot garbage based on my experience with them in racecar world.

Click to expand...

Saw this in another thread regarding Mishimoto

Check Full Race i believe they make a Gen 2.

https://www.full-race.com/store/eco...and-raptor-ecoboost-freakoboost-trans-cooler/

pastorwug said:

WELL, the only other choice it seems is the expensive Mishimoto tranny cooler for $300+.
I know they make nice stuff but their customer service seems to be very slow most of the time.
Not sure what to do, hoping someone who has perhaps installed the Saudi Gen 1 into a Gen 2 will chime in.

Click to expand...

Do you care about warranty at all? If yes - then AVOID any of the large, obvious, red flag "mod waving' "FMIC's" - FORD can see your modified from inside the service bay door looking out to the parking lot AND you're restricting the cooling ability of the stock engine rad. CVF, Mishimoto, wagner, Whipple & others make upgraded intercoolers that will mount in the stock location w/o obviously announcing their presence OR causing you to heavily modify the stock setup of the vehicle for install

I dont care what vendors/mods want - I'm just dropping truth bombs

If any one can take a picture for the USDM oil cooler, and I will post mine, since I own a 19' raptor and I'm in SA currently

Workshop Manual shows USDM and SA use the same transmission cooler design and components.

Are you somehow exceeding the capability of the factory system?