electrical buzzing after shut off

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

jreaper

Member
Joined
May 31, 2020
Posts
11
Reaction score
3
Location
Michigan
I have a 2012 GEN 1. When I got home after twottacking, I shut my truck down and immediately heard a buzzing/whining noise. Thought it would go away and rechecked it 5-10min later and still buzzing. Sounds loudest from transmission pan area, but not super loud. Only way I can get it to stop is to disconnect the batt. Reconnect and noise stays gone until key is turn on then it comes back.
I had the dealer do the leadframe a few months ago under extended warrenty.

Any ideas?
 
OP
OP
jreaper

jreaper

Member
Joined
May 31, 2020
Posts
11
Reaction score
3
Location
Michigan
Dealer said they couldn't repeat but did hear it with the key on(stethoscope on trans pan) said was normal.

Today after work I tried to start my truck and the batt. was dead. Jumped it and went to drive away and it was stuck in 5th again, like before the leadframe was replaced. No codes(p0720,p022 for leadframe warranty)either. Just some from the dead batt.

Is my new leadframe or trans malfunctioning and killing my batt?
 

911 Crazy

FRF Supporting Member
Supporting Member
Joined
Jul 23, 2019
Posts
7,653
Reaction score
3,134
Location
Maine
I have a 2012 GEN 1. When I got home after twottacking, I shut my truck down and immediately heard a buzzing/whining noise. Thought it would go away and rechecked it 5-10min later and still buzzing. Sounds loudest from transmission pan area, but not super loud. Only way I can get it to stop is to disconnect the batt. Reconnect and noise stays gone until key is turn on then it comes back.
I had the dealer do the leadframe a few months ago under extended warrenty.

Any ideas?

Is that done by scouring the talent at the local beach?
 

midwest gen 1

Member
Joined
Sep 29, 2023
Posts
1
Reaction score
1
Location
Barrington Illinois
Dealer said they couldn't repeat but did hear it with the key on(stethoscope on trans pan) said was normal.

Today after work I tried to start my truck and the batt. was dead. Jumped it and went to drive away and it was stuck in 5th again, like before the leadframe was replaced. No codes(p0720,p022 for leadframe warranty)either. Just some from the dead batt.

Is my new leadframe or trans malfunctioning and killing my batt?
Did u ever figure out the issue?
 
Top