What did you do to your Raptor today? (Gen2)

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Mbdurham

Full Access Member
Joined
May 10, 2019
Posts
499
Reaction score
515
Location
Georgia
I tucked the shroud in (but put the stock bumper back on).


Sent from my iPhone using Tapatalk Pro
I ended up just pulling out the whole bottom shroud and trimming the side shrouds up so they lined up with the clips


Sent from my iPhone using Tapatalk Pro
 

Nick@Apollo-Optics

Supporting Vendor
Supporting Vendor
Joined
Apr 3, 2011
Posts
7,391
Reaction score
3,055
Location
Houston, TX
Getting closer...should all be back together tomorrow...thanks again Nick...Think I’m going to remove the recovery hooks or move them back to the empty skid plates holes though [emoji848] then rear bumper and lights this weekend

dcf610d64da51733e2ad8169643bafda.jpg

0da1be1a9558a13c2ad06809b3282eed.jpg
54c760dcbfe7e3b4e3b296d24b444dfe.jpg


Sent from my iPhone using Tapatalk Pro

Truck is looking good, man! Can't for it to all come together!

Installed my APR carbon fiber hood vent to match the fender vents today.
APR’s products are top notch and flawless. Glad I decided to spend a little more money for the “good stuff”.

View attachment 131163

View attachment 131164

Looking sharp, Brad! Glad we could help get you setup with that carbon!
 

MudLovingFJ

Full Access Member
Joined
Aug 29, 2019
Posts
148
Reaction score
102
Location
Orange, CA
any difference in sound?

I only went for a quick test drive after install so my initial impressions are limited.
I did notice a little better low speed light throttle response but it’s too early to be sure yet. Turbos do spool a little quicker/louder.
I should note my truck is a 6/19 build date and did not have the factory intake silencer rings in the intake tubes. I did think the factory spool noise was pretty decent and that’s why.
 

Johnkn

FRF Addict
Joined
Nov 29, 2018
Posts
1,252
Reaction score
888
Location
LaPlata, MD
What's the install process on the APR hood vent? Looks good. I wish they made it just a little taller / more aggressive to differentiate it more from the stock vent..
 
Top