GEN 2 Bora Wheel Spacers Installed

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

FlyingRaptor

Member
Joined
Dec 21, 2017
Posts
32
Reaction score
37
I bought some Bora wheel spacers from @BBLV here on the forum and installed them on my 18 Raptor along with upgraded 19 Beadlock Wheels. Install was simple and didnt take more than an hour to complete.


I first removed the wheels and clean up surface area of wheels and rotors.
IMG_1825.jpeg

IMG_1826.jpeg

IMG_1827.jpeg
IMG_1828.jpeg

Then I used red loctite and installed the lug nuts that came with the spacers to 150 lbs/ft.

IMG_1829.jpeg
 
Last edited:

STP

Member
Joined
May 30, 2019
Posts
27
Reaction score
10
Location
Washougal, WA
Just put 1.5" spacers on my 2011 Gen I. Pushed them out just right. I think 2in would have been too much and an inch not enough. Your stance looks good!
 

Johnkn

FRF Addict
Joined
Nov 29, 2018
Posts
1,252
Reaction score
888
Location
LaPlata, MD
Did you have to trim the factory rear wheel studs? I have a set of 1.25" Boras being delivered this week.
 
OP
OP
FlyingRaptor

FlyingRaptor

Member
Joined
Dec 21, 2017
Posts
32
Reaction score
37
Did you have to trim the factory rear wheel studs? I have a set of 1.25" Boras being delivered this week.


I did not have to trim the studs, but I have the 1.5" spacers. Below is a picture showing how far they stuck out with the 1.5's. There is a recess in the factory wheels so there might be enough room with yours sticking out an extra 1/4".

IMG_1833.jpeg
 

Johnkn

FRF Addict
Joined
Nov 29, 2018
Posts
1,252
Reaction score
888
Location
LaPlata, MD
Ok, thanks, I have the same 19 wheels. Does Bora recommend red locktite? I was going to use the blue as they will need to be removed during brake service. Thanks
 
Top